 |
| Top > Procedure > EMC-noise > Conduction noise |
Conducted noise is measured using a equipment called a LISN (Line Impedance
Stabilization Network) .
Measure the noise that is transmitted from the power supply equipment and output through the input line.
Below is a picture of LISN and a sample noise waveform.
Explains the equivalent circuit for conducting noise measurement and the causes of noise generation.
The method of suppressing conduction noise differs depending on the frequency band.
See below for noise countermeasures for each frequency band.
※Please note that the problem may not be resolved.
This file introduces noise suppression methods for conduction noise, mainly at 0.15 to 0.5MHz.
This file introduces noise suppression methods for conduction noise, mainly at 0.5～10MHz.
This file introduces noise suppression methods for conduction noise, mainly
at 10～30MHz.
EMC noise can be reduced by replacing the transformer without changing the power supply circuit or PCB layout.
Introducing a method to solve EMC noise by improving the transformer structure.
 |
In rare cases, the problem may not be resolved. |
 |
 |